Spectra-precision Survey Pro v3.80 Recon GPS User Manual User Manual download pdf (Page 75)

Post Processing Data

Collection

Post processing data collection uses GPS raw data stored in the

receiver’s internal memory. Raw data from multiple receivers is

combined and then PC software is used to process the base line

measurements. The following section describes how to start

recording raw data in the receiver internal memory for both post

processing only data collection and simultaneous RTK and post

processing data collection.

Field Procedure

Turn On Post Processing

Go to Settings from the Job menu.

On the Post Process

card, specify a non-zero recording

interval.

Note: For simultaneous RTK and post processing data collection,

this is all you need to do. Receiver recording will be started

automatically when you configure the RTK base and rover. Data

collection sessions will be completed automatically when you occupy

an RTK point. If you wish to do post processing only data collection,

you need to complete the next step before tapping OK.

On the Receiver card, select the correct

GPS Mode

. If you

want to use simultaneous RTK plus post processing data

collection, select

RTK

mode. If you want to do post processing

only data collection, either static or stop and go, set the

GPS

Mode

Post Process

Tap .

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 94 95

No comments

Spectra-precision Survey Pro v3.80 Recon GPS User Manual User Manual Page 75