Spectra-precision FAST Survey User Manual Page 61

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 60
English
53
Using an External Radio with a ProMark 220
Connect the radio to the receiver through a POGO cable (this
accessory is available from Spectra Precision):
For most models of supported radios, the POGO cable that
should be used is the one with bare wires on radio side
(Unterminated POGO cable P/N 111659), which means
you have to add a connector that is suitable for your radio
model. The POGO cable pinout is provided in the left-
hand column. For a base, an external DC source is
recommended to power the radio (used as a transmitter).
Some radio models can be configured directly from within
FAST Survey.
If the ProMark 220 is used as a rover and you purchased
a Satel Easy radio from Spectra Precision, then the POGO
cable is provided with the suitable connector (it’s part of
the radio kit P/N 802144). You just need to connect this
cable between the GNSS receiver and the Satel radio. The
Satel radio should be configured separately (this cannot
be done from within FAST Survey).
If the ProMark 220 is used as a base with a Satel Easy
radio, Spectra Precision recommends the use of the Y-
shaped POGO cable kit P/N 90247 allowing you to
connect the radio directly to the GNSS receiver and to
power both the GNSS receiver (through pin +DC IN) and
the radio from a single, external DC source (Reminder:
This setup does NOT allow the receiver’s internal battery
to be charged). The Satel radio should be configured
separately (this cannot be done from within FAST Survey).
*: DC power input
(12-28 V DC/2 A external battery)
**: DC power output to UHF radio
(12 V DC/0.5 A)
GND, 0.5 A
+DC IN*
+DC OUT**
GND, 2 A
UHF_RX
UHF_CTS
UHF_TX
Black
White
Yellow
Green
Blue
Red
Black
Orange
UHF_RTS
POGO
Connector
POGO Cable
P/N 111659
Page view 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments